Note! If you choose to use your DD-WRT router as an access point, you may want to disable the Wireless network in Vilfo. To make future changes in DD-WRT you will need to do so using the IP address assigned to your DD-WRT router by Vilfo. Under Device IP address, enter the IP address of your DD-WRT router that you wrote down previously. Locate your DD-WRT router in the list of devicesĬlick on your DD-WRT router in the list of devices Officially, the latest stable release is V23 SP2. Although DD-WRT provides lots of advanced features for a consumer-grade router, it can be confusing to select a version. In order to be able to access the DD-WRT user interface after the change has been made, you may need to change the IP address of the DD-WRT router to match that of Vilfo. One way to create a hotspot is by using the powerful, free, and open source DD-WRT firmware loaded onto a compatible router, such as the Linksys WRT54G. Step 2: Changing the DD-WRT router IP in Vilfo Under Network Address Server Settings (DHCP), enter the following settings.Ĭonnect a network cable between the LAN port on Vilfo to the WAN port on your DD-WRT router
Under Network Setup, enable the option Assign WAN Port to Switch By default Vilfo uses 255.255.0.0, if the subnet mask differs from the one shown in Vilfo, enter the new one to match the one Vilfo use The lan ports are all fine, but I cannot trust the 802.11n connection. Wireless is completely unreliable and goes out constantly. Subnet Mask: Check that the subnet mask is the same one Vilfo use. I am currently using dd-wrt on the Netgear N600. Write down the IP-address shown here (By default, 192.168.1.1) Local IP Address: Verify that the IP address entered here is in the same subnet that Vilfo use. (tp-link wdr3600 with v24-sp2 (02/19/14) std) does anyone have a suggestion openvpn log: Log Serverlog Clientlog 20140223 03:55:53 W WARNING: normally if you use -mssfix and/or -fragment you should also set -tun-mtu 1500 (currently it is 1400) 201402. What should I be using to access my LAN remotely I used to be able to access my Server that is on the LAN, but it now has it's own VPN. Yes I am using a router that my ISP has given me. Under Network setup, check the following options: hi guys, i cant use airvpn with my router. Running DD-WRT v24-sp2 (10/10/09) std firmware. Under WAN Connection Type ➝ Connection Type, select Disabled